Unit installation

▼ PARTS LIST

• GJY1 79 EZX (US/CANADA), GJY2 79 EZX (MEXICO)

Part Part name Qty. Part Part name Qty. Part Part name Qty.

Car-navigation

unit

Lid-NAVI

Installation

instruction

Owner’s

manual

▼ REQUIRED TOOLS

☆Phillips screwdriver ☆Torque wrench ☆Tape-wrapped flathead screwdriver

☆Socket wrench (10mm) or Spanner wrench (10mm) ☆Clean rag (soft cloth)

1. PARTS

• Before installation, verify that the kit includes all the following parts and that they are free of dirt, scratches,

or damage.

NOTE:

2. BEFORE INSTALLATION

• To prevent short related accidents while performing procedures, disconnect the negative battery cable

before beginning any work.

• When disconnecting the connector, hold the connector itself to remove while pressing the connector lock.

• Do not apply excessive force to the wiring harness as it could cause an open circuit.

• When locking connectors, listen for a click that will indicate they are securely locked.

• Be careful not to pinch the wiring harness. Otherwise, the harness may be broken.

WARNING

• Refer to the applicable Workshop Manual for removal and installation of vehicle parts. Not following the

procedures for removal/installation in the Workshop Manual could result in an accident or vehicle

malfunction.

• When the negative battery cable is removed, the clock, radio, trip meters and other memories will be

erased. Before performing work, record the content of the memory.

NOTE:

• When removing and installing vehicle parts, make sure they are clean with no scratches. Also, be sure to

cover the vehicle body with protectors or mats when removing/installing parts to prevent scratches and dirt.

CAUTION

NOTE: Requires factory installed 5.8” display. Not needed on vehicles with the

Technology Package (they already have factory navigation). All parts are the

same as OE (including SD card KD37-66-EZ1).