Unit installation

3
Negative battery cable disconnection
1. Set the selector lever to P range.
(AT vehicles only)
2. Disconnect the negative battery cable and wrap tape around it
to insulate.
CAR-NAVIGATION UNIT INSTALLATION
Pocket Assy Removal
1. Open the lid-pocket, remove the pins (1 each, left and right
)
from the underside of the lid-pocket, and remove the lid.
3. VEHICLE PARTS REMOVAL
z The following vehicle parts removal procedure is for left-hand drive vehicles. Perform the same procedure
for right-hand drive vehicles.
NOTE:
•
When the negative battery cable is connected during
operation, it may cause electric shock or other personal
injuries. Disconnect the negative battery cable before
removal/installation.
WARNING
•
When removing/installing the parts, park the vehicle on
level ground and apply the side brake securely. Be sure to
turn the ignition switch off, otherwise the vehicle can move,
causing personal injury or vehicle damage.
WARNING
4. INSTALLATION
Negative
battery cable
Lid
-
P
oc
k
e
t
Pin
•
Dispose of the removed lid-pocket.