Unit installation

4
2. Insert two pieces of wire or two bands (use hard acrylic bands)
into the locations shown in the figure and secure both ends.
(Figure shows bands being used)
3. Pull the wires or bands in the direction shown in the figure and
pull out the pocket assy.
4. Remove the wiring harness clips (2) on the back of the pocket
assy.
5. Disconnect the connectors (3).
Car-navigation unit Installation
1. Connect the USB, GPS antenna, and +B/ACC connectors to the
car-navigation unit.
•
Be careful not to apply excessive force to the wiring
harness when removin
g
the connectors.
Wire or band
Lower panel
Pocket
assy
Wire or band
U
S
B
connector
+B
/
A
CC
connector
G
P
S
antenna
connector
C
ar-navigation unit
A
A
SEC. A-A
Lower panel
Vehicle
front
Harness
clips
C
onnectors
•
Reuse harness clips(2).
• Dispose of the removed pocket assy.