Unit installation

7
1. Connect the negative battery cable and perform an operation check by referring to the owner’s manual
applicable to the vehicle.
2. If there is any malfunction, disconnect the negative battery cable and verify that each connector is properly
connected and the wiring harnesses are not damaged or pinched, then perform the operation check again. If it
does not operate normally, contact the dealer where the unit was purchased.
■ After installing the car-navigation unit, verify the connections of the GPS antenna, +B/ACC, and USB
connectors using the following procedure:
Connection verification of GPS antenna connector
1. Turn the ignition switch to the ON position.
2. After the opening screen ends, the Audio off screen is
displayed.
3. Press the POWER/VOLUME dial to switch to the on screen.
4. Press the POWER/VOLUME dial and SEEK UP button at the
same time on the Audio on screen (press POWER/VOLUME
dial a little earlier).
5. After switching to the AUDIO system screen, touch the
buttons in the order of “1”, “5” and “ENTER” on the screen.
5. OPERATION CHECK
Audio off screen
POWER/VOLUME dial
S
EEK UP button
Audio on screen
POWER/VOLUME dial