Technical data

6
the motor. Should the protection trip as a result of anomalous operation, such as the
grinding blades jamming, the appliance must be turned off using the on-off switch,
UNPLUGGED FROM THE MAINS, AND SKILLED TECHNICAL PERSONNEL
CONTACTED. NEVER PERFORM ANY WORK ON THE APPLIANCE WHILE IT
IS ATTACHED TO THE MAINS, TO AVOID THE RISK THAT MOTOR TURNS
ON SUDDENLY.
If the appliance overheats as a result of the motor stopping, allow the appliance
to cool down before performing any repair work.
•
SAFETY SCREWS
•
The hopper must always be attached to the upper grinding blade
holder using the relevant screw, which must not be removed by
the user under any
circumstances.
•
In order to prevent the
adjustment disk from
being removed - which
would make the rotating
parts accessible - there
is a safety screw on the actual disk: said screw must be positioned in whichever
of the two holes on the disk enables the wider and most suitable range of grind-
ing adjustment, and must not be removed by the user under any circumstances.
•
COFFEE OUTLET GUARD
The coffee outlet guard must always be fixed to the doser using the relevant screws,
wich must never be removed by the user.
The removal of the coffee outlet guard can be done by skilled technical personnel
only after disconnecting the appliance from the power supply by unplugging.
Before reconnecting the appliance to the power supply, fix the safety device to the
doser by the relevant screws.
11) WARNINGS REGARDING SAFETY
This electrical appliance must be used in conformity with the rules in force governing
safe operation.
•
WHEN OPERATING THE APPLIANCE, BEWARE OF THE MOVING MECHANI-
CAL PARTS’ IN THE AREA OF THE GRINDING BLADES AND OF THE GROUND
COFFEE OUTLET.
BEFORE REMOVING
THE HOPPER FR
OM THE GRINDING SYSTEM, DISCON-
NECT THE POWER SUPPLY.
AVOID REMOVING FOREIGN BODIES FR
OM
THE GRINDING SYSTEM OR
HOPPER
SAFETY
SCREW
AL
TERNA
TIVE
TAPPED HOLE
DISK SAFETY SCREW
COFFEE
OUTLET GUARD