Quick Start Guide

The amplier features an innovative AUTO SENSE turn-on circuit. It is only used when adapting your

source unit to high level inputs and allows you to avoid the purchase of an expensive LOC or

Line Output Converter.

To use the feature you will need to modify a set of RCA adapters to allow your factory radio or source

unit to feed signal into the amplier inputs.

When the amplier is in the DC on/Autosense the amplier will turn on when it senses a audio signal

(playing music). It will also turn off when it senses there is no audio signal (no music playing). In this

conguration you will not need to wire the REM (remote turn on wire).

Connecting a RCA cable directly to a HIGH level input (speaker wire output) the next steps is how to

modify a set of RCA’s to connect them to a HIGH level input

NOTE - If the RCA’s are plugged into the amplier and the TURN ON MODE is in the DC ON

position, the amplier will NOT turn on. Please re-read this document or hire a professional installer.

If you are using normal RCA outputs from a source unit with a standard

turn on wire – this switch should be in the REM ON position.

IMPORTANT

This amplier has a special feature for integration with

factory audio systems or other inputs that will require the

use of the “high level” input. Failure to use these feature

correctly will cause the amplier to not turn-on.

Please read this notice carefully.

AUTO-SENSE

Technical Guide

LOW LEVEL

If you are using a factory radio (OEM) to drive the amplier input.

Push the button to DC ON

HIGH LEVEL

TURN ON

MODE

DC ON

REM ON

SIGNAL SENSE ON