Quick Start Guide

Next, you need to make this quick adapter with a spare set of RCA cables.
You will need: Wire Cutters, Soldering Iron, Heat shrink (or electrical tape), and Impedance Meter.
Step 1) Take a pair of RCA’s and cut one end off.
Step 2) Strip back the plastic shielding.
Step 3) After removing the plastic sheathing there
will be two separate wires. Next, you will need to test
with a multimeter to determine which is positive and negative.
Step 4) Connect these four contacts to your speaker
connections from your radio or powered source unit.
Step 5) Using a multimeter select OHM/continuity and put the
leads on the RCA end and the stripped wire to determine
which wire matches the center pin of the RCA connector.
Step 6) Once it is determined which stripped wire is
(+) positive and (-) negative you would wire that to
your high output (speaker wires) from your source unit.
Then make your solder connections.
+
+
+
-
+ positive
- negative
MB Quart products are designed and engineered in the USA by
www.maxxsonics.com
MBQ AUTOSENSE - rev3