Owner's Manual

11
KICK PANEL SPEAKERS
MOUNTING THE KICK PANEL SPEAKERS (Continued)
STEP 6 – PLACE PASSENGER SIDE KICK PANEL
Place passenger side kick panel pod in its location as shown in
Figure 14-5. Ensure the positioning lines up with the holes you’ve
drilled.
STEP 7 – PUSH OUTER BOLTS THROUGH FENDER AND
MOUNT DRIVER’S SIDE KICK PANEL
With the included hardware push (1) bolt and (1) washer through
the inner passenger side fender well into the threaded insert of the
driver’s side kick panel pod. This leaves only the head of the bolt
visible behind the tire.
Once the rst bolt and washer are threaded in, insert and thread
the second bolt and washer for a total of two bolts/washers
attaching the kick panel pod to the passenger side fender well as
shown in Figure 14-6.
NOTE - Make sure that the wires behind the subwoofer enclosure
on the passenger side remain accessible for connecting to the
amplier harness. Use some painters tape to keep them from
getting blocked by the enclosure if necessary.
STEP 8 – CONNECT WIRING INTO KICK PANEL
Connect wiring from your amplier to the wire harness from the kick panel as indicated. Route the wire away
from moving parts or sources of moisture and heat.
● SOLID GRAY - Right Front Speaker +
● GRAY/BLACK - Right Front Speaker -
● RED - Illumination + (Optional LED Light Ring Required)
● BLACK - Illumination -
Figure 14-5
Figure 14-6
Thread bolts/washers into kick panel pod