Owner's Manual

12
©2020 Maxxsonics USA, Inc.
INITIAL TESTING
This step is to conrm that everything is working before you put the vehicle back together.
STEP 1 – RECONNECT THE BATTERY
With the kick panel speakers wired to your amplier, you
can now reconnect the negative terminal of the negative
battery cable as indicated in Figure 19-1.
STEP 2 – TURN ON IGNITION
Turn the ignition key to the ACC position and push the
PWR button on your source unit.
STEP 3 – INITIAL CHECKS
With the system power “ON” use the list here to check
the system for all of the following:
● CORRECT LEFT/RIGHT BALANCE - Make sure you are using the controls on the source unit to confirm
“LEFT” is the left-side channel and “RIGHT” is the right-side channel.
If everything is working and producing sound, you can do any fine tuning based on your source unit and/or
amplifier’s capability.
● AMPLIFIER CROSSOVER RECOMMENDATIONS
● If you do not have a subwoofer, leave the speakers to run full range.
● If you DO have a subwoofer, use a 60Hz high pass crossover on the amplifier connected to the kick panel
speakers.
Figure 19-1
INITIAL TESTING