Owner's Manual

Before you start
/! ·. · CAUTION /!
·,,
Marly new andJac:;tory_ radios require ·a reset code when
disconr.iected from battery power. This is an anti-theft
featur~,/Before unplugging power, you must determine if
your.radio/source unit requires a reset code. Cfieck the
operation 1 mcu1Ual for your vehicle or contact the dealer .
. ,• · . .... . . .
. -~---•~ ....... ..!!...: _ _ ._ •. - . • .. :.. - ~ ,• •
Power cable size
and fusing
It is critical to use the proper power
and ground cable. Select the size
listed here for your amplifier model.
Always use high quality copper
cable. Visit our website for multi amp
system cable recommendations.
Be sure to use the proper fuse size
for each model. Some models require
an external fuse.
Installation
- - - -
D Disconnect
· Negative Battery
Terminal
Place terminal in a secure
position so that it won't
accidentally contact the
negative battery post
'E) .. Run Cable~
Properly route power,
speaker and RCA cables
through the vehicle.
, m Mount Ampiifier
Choose a mounting location
that will provide adequate air
ventilation. Mount the amplifier to
a secure surface. Do not mount
the amplifier upside down.
Model Fuse Size
1-30A ate
1-30A ate
Cable Size
NA2-400.2RC
NA2-320.4
NA2-400 .1
NA2-500.5
IJ•t!b
1-30A ate •
1-40A ate
For power cable runs over 20 feet,
8ga is recommended.