Owner's Manual

6
©2020 Maxxsonics USA, Inc.
DASH AREA DISASSEMBLY 2013-2018 (Non-Turbo S) RZR - Continued
STEP 5 – REMOVE DASH FASCIA CENTER HARDWARE
Remove (4) Torx screws from the front of the dash through the openings shown in Figure 5-6. The rst set of
Torx screws will come out allowing access to the second (upper) set further back in the dash. Next, pull the
only the center of the dash loose as shown in Figure 5-7. This will provide further wiring access.
STEP 6 – REMOVE DASH FASCIA HARDWARE
Using a large panel removal tool, release the side clips from the passenger’s side front dash assembly as
shown in Figures 5-8 and 5-9. Slowly ensure you account for all clips removed.
STEP 7 – REMOVE THE GLOVE BOX
Remove (2) 10mm bolts on the top of the glove box
where it is fastened to the grab bar framework. See
holes in Figure 5-10. The glove box will easily slide out.
This will make the kick panel area more accessible and
allow for easy wire running to wherever you place the
amplier.
Go to page 10 for kick panel installation steps on these
model year vehicles.
Figure 5-7Figure 5-6
Figure 5-9Figure 5-8
Figure 5-10
DISASSEMBLY