Installation Instructions Model: Polaris Ranger Description: Subwoofer Install Part Number: MBQRG-SUB-1 Assembly Time: 60 Min (1-Hours) Before you begin, read through these instructions and check that all parts are present. Always disconnect negative battery terminal prior to installation. Please note that MB Quart cannot assume any responsibility for damage resulting from incorrect installation. Parts List No.
Disassembly ● Remove hood by turning two latches ● Remove four push pins from the passenger side center console ● Remove five push pins from the driver side center console Page 2 of 11
Disassembly ● Remove underseat tray from passenger side DISCONNECT NEGATIVE BATTERY TERMINAL ● Lift center console upward starting at cupholder and remove from vehicle Page 3 of 11
Harness Installation ● Route the subwoofer extension harness extension harness from the middle of the dash out the grommet toward the front of the vehicle ● Pass the wires from the grommet to the radiator cap opening (if other wire present zip tie along) ● Pass the wiring around any moving parts and down the frame toward the center console and secure in place with zip ties Page 4 of 11
Harness Installation ● Run along air intake securing with zip ties to the power bus bar harness ● Route subwoofer harness to the passenger side of the battery ● Drill 1.
Amplifier Adjustment ● Adjust the NA2-400.
Amplifier Installation ● Plug inpower harness pigtail to amplifier and make appropirate power, ground, and remote connections ● Connect the subwoofer extension harness to the NA2-400.1 amplifier harness ● Connect RCAs to the NA2-400.
Subwoofer Installation ● Drill three 1/8” holes at marked indents in floor (only drill deep enough to get through first layer of material) ● Place subwoofer enclosure under passenger seat and secure with three high-low T25 Torx screws and washers Note Use two picks to align enclosure with holes in vehicle and also use provided bit extension to reach rear screw where the arrow is ● Connect the subwoofer enclosure harness to the subwoofer extension harness Page 8 of 11
Reassembly ● Place center console in the vehicle sliding forward then down ● Insert four push pins on passenger side console ● Place five push pins on driver side center console Page 9 of 11
Reassembly ● Place battery cover into place RECONNECT NEGATIVE BATTERY TERMINAL ● Turn vehicle and radio on and enjoy the music Page 10 of 11
FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a mobile installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
