Owner's Manual

6
Can-Am X3 Source Unit Mounting Instructions
7
8
7) Connect the electrical
plug and, if used, RCA
audio and USB cables. Test
source unit functionality and
sound before nal mounting
and installation. See Trou-
bleshooting section on page
22 if needed.
8) Place the source unit in
the na installation location
with wiring neatly secured
and zip tied in place. Attach
the four included screws
through the housing’s
mounting holes drilled out
earlier. Two T-25 32mm
screws (front) and two T-25
24mm screws (back).
5
5) Using battery-powered
cordless drill with a 9/64”
drill bit, drill two (2) mount-
ing holes in the dimpled
areas as indicated. As the
material is plastic, there is
very little pressure need-
ed..
6
6) Drill the remaining two (2)
mounting holes at the back
of the housing as indicated.
Again, as the material is
plastic very little pressure is
needed.