Owner's Manual

13
The illustrations below describe the various controls. Refer to
The gain control purpose is to match
the output of your source signal to the
detailed instructions.
or low frequencies. The NA2-400.2 offers
The Boost Switch will increase the signal
12dB at 45Hz. Be aware this setting can
cause distortion if the gain is not set
properly.
1.
turned down (counter clockwise).
2.
turned down. Make sure the source unit controls; balance, fader, bass and
treble are all set to center or “0” adjustment. Make sure that the green LED on
3. Play a clean musical selection of which you are very familiar. CD is preferred.
Do not use radio signals for level setting. Hit play and start turning the volume
of the source unit up.
4. Stop increasing the source unit volume when you reach 3/4 (about 75%) or until
you hear speakers begin to slightly start producing distortion.
5.
the level down (counter clockwise) until the distortion is eliminated. Small
Settings
A
is properly adjusted to match the signal
output level of your source unit.
THIS IS NOT A VOLUME CONTROL!
Level Setting
B
FRONT
L
R
REAR
L
R
INPUT
L
R
GAIN
MIN MAX
X-OVER
LPF FULL
1
3
3
2
NA2-400.2
X-OVER
HP
OFF
LP
INPUT
L
R
LEVEL HP LP
9V 0.2V 15Hz 300Hz 50Hz 300Hz
1
2
5
GAIN Adjustment
X-OVER Switch
BOOST Switch
The Low Pass Filter will cut off the
frequencies above the setting. The High
Pass Filter will cut off the frequencies
below the setting.
The Subsonic Filter will cut off the
frequencies below the setting. If using
with a subwoofer, the setting should be
set between 15-25Hz.
3
4
Frequencies Adjustment
SUBSONIC Adjustment
1
3
4
5
NA2-400.1
BOOST
0dB 12dB
INPUT
L
R
LEVEL
9V 0.2V
LPF
50Hz 150Hz
SUBSONIC
15Hz 50Hz
Two Channel Amplifier
Mono (Subwoofer) Amplifier
either a low pass (LP) or high pass (HP) filter.
FINE TUNING
After you have conrmed and tested that all components are working, you can ne tune the amplier
settings. Through hundreds of installations we have determined the following settings are ideal for the Can-
Am X3 UTV-Tuned Audio Packages. Reference source unit volume level for these settings is 30-35 with no
boost in bass, treble or EQ settings.
NOTE – Gain control, it is important to adjust each amplier gain as described in the manual. Remember,
these settings are NOT volume controls. Gain controls, properly adjusted help properly balance the system
sound between lows, highs and minimize distortion that comes from the source unit. Listen for a clear, crisp
audio sound. The ideal gain setting should allow full volume from the source unit without audible distortion.
FINE TUNING