Owner's Manual

SPECIFICATIONS
GENERAL
Power Supply Requirements:
DC 12 Volts, Negative Ground
10 Ampere (max.) Current Drain:
Maximum Output Power:
4 x 16 watts into 4 Ohms@ 14.4V DC
4.0V (with AUX , USB, or AM/FM Source) Preamp Output Voltage:
Chassis Dimensions
Tone Controls
Bass ( at 100 Hz)
Treble (at 10 kHz)
RADIO
Frequency Coverage
IF
Sensitivity
Stereo Separation
6-3/4" (W) x 2" (H) x 3-3/4" (D)
*Note: Installation depth requires 3-3/4" minimum
FM
± 10dB
± 10 dB
87.5 to 108 MHz
10.7 MHz
4µV(S/N=30dB)
>25dB
AM
520 to 1710 kHz
450 KHz
36dBuV(S/N=20dB)
N/A (AM is Mono)
TROUBLESHOOTING
Symptom
Cause
Solution
No power.
The car ignition switch is If the power supply is
not on. connected to the car accessory
circuits, but the engine is not
moving, switch the ignition key
to "ACC".
The fuse is blown. Replace the fuse.
No sound.
Volume is in minimum Adjust volume to a desired level.
Wiring is not properly
Check wiring connection.
connected.
The operation The built-in
microcomputer Press the reset button.
keys do not is not operating properly
work. due to noise.
The radio does
The antenna cable is not
Insert the antenna cable firmly.
not Work. The connected.
radio station
The signals are too weak.
Select a station manually.
automatic
selection
does
not work.
12