Technical data

42 Brocade MLX Series and NetIron Family Documentation Updates

53-1002805-03

Transparent forwarding of L2 and L3 protocols on a VLL for CES and CER

Member of 1 L2 VLAN(S) (tagged), port is in tagged mode, port state is

Forwarding

STP configured to ON, Priority is level0, flow control enabled

Priority force disabled, Drop precedence level 0, Drop precedence force disabled

dhcp-snooping-trust configured to OFF

mirror disabled, monitor disabled

LACP BPDU Forwarding:Disabled

LLDP BPDU Forwarding:Disabled

L2L3 protocols Forwarding:Disabled

Not member of any active trunks

…

The following output example shows the show interfaces ethernet slot/port command with the

forward-all-control command enabled.

Brocade(config-if-e1000-1/1)#forward-all-protocol

Brocade(config-if-e1000-1/1)#show interfaces ethernet 1/1

GigabitEthernet1/1 is up, line protocol is up

STP Root Guard is disabled, STP BPDU Guard is disabled

Hardware is GigabitEthernet, address is 001b.eda3.f841 (bia 001b.eda3.f841)

Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx