Technical data

44 Brocade MLX Series and NetIron Family Documentation Updates
53-1002805-03
Manual deletion of an OpenFlow rule
1
Manual deletion of an OpenFlow rule
The command clear openflow flowid Flow ID has been implemented in NetIron 5.4.00c. This
command adds an enhancement to delete a single OpenFlow rule based on a Flow ID.
Brocade# clear openflow flowid 6
Syntax: clear openflow flowid [Flow ID]
The command will delete a single OpenFlow rule with the given [Flow ID]. The command will delete
the rule irrespective of the state it is in (ACTIVE, PENDING_ADD, PENDING_MODIFY,
PENDING_DELETE). The same rule can be added again later from the controller if needed.
However, the flow-id of the deleted rule cannot reused again.
NOTE
The clear openflow command cannot be used simultaneously when there is deletion from a
controller already in progress. The clear command will exit with the following message: “Deletion
from Controller in progress..Try again later !”
Show tech enhancement for OpenFlow
The show openflow tech-support command has changed to show tech-support openflow. The
changes ensure that the OpenFlow feature is in line with all other feature commands.
Brocade# show tech-support openflow.
Syntax: show tech-support openflow
This command will now capture the output of the following commands:
• show openflow datapath-id
• show openflow controller
• show openflow interface
• show openflow flows
• show versions
• show interfaces
TABLE 17 Feature support Table
Brocade NetIron
XMR Series
Brocade MLX
Series
Brocade NetIron
CES 2000 Series
BASE package
Brocade NetIron
CES 2000 Series
ME_PREM
package
Brocade NetIron
CES 2000 Series
L3_Prem
package
Brocade NetIron
CER 2000 Series
BASE package
Brocade NetIron
CER 2000 Series
Advanced
Services package
YYYYYYY