Technical data

70 Unified IP MIB Reference
53-1002805-03
Management module diagnostics
SAND access - Passed
Valere power Supply 0 Passed
Valere power Supply 1 Passed
Power Supply access - Passed
Port 0 passed
Port 1 passed
Port 2 passed
Port 3 passed
Port 4 passed
Port 5 passed
Port 6 passed
Port 7 passed
Port 8 passed
Port 9 passed
Port 10 passed
Port 11 passed
Port 12 passed
Port 13 passed
Port 14 passed
Port 15 passed
Port 16 passed
Port 17 passed
Port 18 passed
Port 19 passed
Port 23 passed
Dx246 Switch Port Loopback - Passed
###- PASS -###
MP-1 OS>
LP (6) [MLX-X 1Gx24 Copper] burn-in started
LP (6) PING test passed
LP (7) [MLX-X 1Gx24 Copper] burn-in started
LP (7) PING test passed
LP (6) (MLX-X 1Gx24 Copper) diagnostic Passed
LP (7) (MLX-X 1Gx24 Copper) diagnostic Passed
###- PASS -###
NOTE
After the completion of diagnostics for the MP modules, the system displays the MP-1 OS>
prompt and then starts the diagnostics for the LP modules.
NOTE
Brocade requires that you remove physical connections to all ports on the module, and all
optics to all ports on the module, so the module does not receive traffic while the diagnostics
are running.
4. Enter the reset command to return the system to normal operation (system reboot).
MP-1 OS>reset
REBOOT S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module CARD_STATE_REBOOT 20 0000.003d.8500
BOOT S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module CARD_STATE_BOOT 20 0000.003d.8500
CARD_STATE_UP S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module CARD_STATE_SW_LOADED 20
0000.003d.8500
UP S1: NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module CARD_STATE_UP 20 0000.003d.8500