Manual

MX-1 Connecting High Level Speaker Wires (no factory amp)
SPEAKER WIRE INPUT
+ - + - + - + - + -
R/F L/F R/R L/R SUB RADIO
MXR-1 REMOTE
CONTROL
BASS REMOTE
VOLUME
MIN MAX
GREEN: PRE-CLIP
YELLOW: SOFT CLIP
RED: HARD CLIP
MXR-1
cut
cut
cut
cut
cut
cut
cut
Not Used
Factory Radio
High Level Speaker Wire Outpus
L/R R/R L/F R/FGround
+ - + - + - + -
High Level Speaker Wire Connections
1. Cut ( ) the factory radio speaker wires from the
radio to the speakers in half.
2. Connect the speaker wires from the radio side to
the MX-1 color coded wires as shown in the diagram.
3. Connect the other end of the wires from the speakers
to the aftermarket amplifier as shown in the diagram
on page ?
4. If you experience audible noise (distortion) in the
speakers upon completion of the installation, connect
the MX-1 “Radio ” ground wire to the factory radio
ground wire as shown above.
+
Connect this end of the speaker
wires to the amplifier
8