Manual

MX-2 Connecting Low Level RCA Cables To Amplifier
Low Level RCA Outputs
REMOTE OUTPUT
BATTERY + w/5 amp fuse
REMOTE INPUT
CHASSIS (-)
Blue
Black
Orange
Red
FRONT / REAR
R
L
POWER
OUT
REM
+
BAT
IN
REM
-
BAT
+
_
+
_
+
_
+
_
Speakers
Aftermarket Amplifier
FRONT REAR
Right / Left Right / Left
REMOTE INPUT
Low Level RCA Connections
1. Use high quality RCA cables to connect the MX-1 to the
aftermarket amplifier per the diagram on this page.
2. Observe the Left (red) and Right (white) polarity as well
as Front and Rear on both MX-2 and the aftermarket
amplifier.
Power Connections
1.Connect the remote (REM OUT) output of the MX-2 to the
remote input on the aftermarket amplifier.
2. Connect the battery (BAT+) terminal to a constant +12
volt source with a 5 amp in-line fuse (not supplied).
Note: Do not install the fuse until the entire installation
is complete and you are ready to test.
3. Connect the remote (REM IN) terminal to the radio
output wire that provides a +12 volt output when the radio
is on and 0 volts when the radio is off. If the radio does
not have a +12 volt output, do not use this terminal.
4. Connect the battery (BAT -) to chassis ground.
11