Manual
MX-2 Connecting High Level Speaker Wires (no factory amp)
Black
Purple/Black
Purple
White/Black
White
Gray/Black
Gray
Green/Black
Green
+ - + - + - + -
R/F L/F R/R L/R RADIO
SPEAKER WIRE INPUT
+
cut
+
cut
+
cut
+
cut
+
cut
+
cut
+
cut
+
cut
High Level Speaker Wire Connections
1. Cut ( ) the factory radio speaker wires from the
radio to the speakers in half.
2. Connect the speaker wires from the radio side to
the MX-2 color coded wires as shown in the diagram
Note: Be sure to follow the wire color code and polarity
chart above.
3. Connect the other end of the wires from the speakers
to the aftermarket amplifier as shown in the diagram
on page ?
4. If you experience audible noise (distortion) in the
speakers upon completion of the installation, connect
the MX-2 “Radio” ground wire to the factory radio
ground wire as shown above.
+
Black: Radio Ground
Purple/Black: Left Rear -
Purple: Left Rear +
White/Black: Right Front -
White: Right Front +
Gray/Black: Right Rear -
Gray: Right Rear +
Green/Black: Left Front -
Green: Left Front +
Color Code / Polarity Chart
L/R R/R L/F R/F
High Level Speaker Wire Outpus
Ground
+
+
+
+
Factory Radio
Connect this end of the speaker
wires to the amplifier
12