Quick Start Guide

Multi-Function Joystick Operation
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Congratulations on your choice of a MBQuart Bluetooth
controller. This “Quick Start” Installation guide is meant to
help you complete a basic installation. For more detailed
information, visit our website at MBQuart.com and go to the
TEQ Support section or the Frequently asked questions.
MOUNTING
The controller is designed to mount in a standard rocker switch
opening for accessories. Do not attempt to remove the unit from the
switch housing. The housing is an integral part of the unit.
The unit itself requires a 0.83 inch (21mm) wide by 1.4 inch (37mm)
high opening with at least 2.5 inches of clearance behind the
mounting surface. Before drilling any holes make sure there are no
obstructions behind the mounting surface.
Keep enough space around the controller if possible to accommodate
the operator’s ngers.
RUBBER GASKET
Make sure the included rubber gasket
remains in place during installation. This
gasket aides in the unit remaining water
resistant.
AUX INPUT – 3.5MM JACK
The 3.5mm input jack is located on the
bottom of the unit. Remember to re-insert
the water resistant rubber plug when not
using the input. The control unit should
always be mounted with the 3.5mm jack on
the bottom.
The multi-function joystick has multiple operations for various
features. Take a minute to familiarize yourself with all of the following
to better and more quickly navigate your new Bluetooth controller.
VOLUME
Slowly turn the controller clockwise to increase volume and counter
clockwise to decrease volume. Turning the dial quickly does not
increase the speed of volume increase or decrease. Under AUX
mode the volume will be controlled by your device.
POWER ON/OFF
A. Press and hold control volume for 3 seconds to power
the unit on/off
3.5MM SIGNAL INPUT
A. the controller will automatically switch from Bluetooth
to the AUX input by plugging you device into the 3.5mm
input.
BLUETOOTH CONTROL
RIGHT/DOWN TOGGLE
A. Toggle right or down to advance to the next track
LEFT/UP TOGGLE
A. Toggle left or down to back up to previous track
Switch Mounting
Wiring
Rubber Gasket
3.5mm Plug
Fuse
Red Wire - 12v Power
Black Wire - Ground
Orange Wire - Accessory
Blue Wire - Remote Output
RCA Cables - Signal Output
The wiring and connections should be secure and away from any
moving parts or extremely hot surfaces.
The RCA signal output can be connected directly to an amplier or
to the auxiliary input of an audio head unit.
The blue remote wire provides a +12V output to turn on an
amplier.