Installation manual

27
Treble:
1. Select the Treble mode (TRE) by pressing the
SETUP button.
2. Increase the Treble by pressing the button.
Decrease the Treble by pressing the button.
3. Control reverts back to volume control after 5
seconds.
Balance:
1. Select the Balance mode (BAL) by pressing the
SETUP button.
2. To adjust the amount of sound output to the
Right speakers press the button.
To adjust the amount of sound output to the
Left speakers press the button.
BAL 00 = Equal sound right and left.
BAL R12 = Right speakers only.
BAL L12 = Left speakers only.
3. Control reverts back to volume control after 5
seconds.
Sound Controls (Continued)
Fader:
1. Select the Fader mode (FAD) by pressing the
SETUP button.
2. To adjust the amount of sound output to the
Rear speakers press the button.
To adjust the amount of sound output to the
Front speakers press the button.
FAD 00 = Equal sound front and rear.
FAD R12 = Rear speakers only.
FAD F12 = Front speaker only.
3. Control reverts back to volume control after 5
seconds.
Subwoofer Line Level Output (SWG):
1. Select the Subwoofer Line Level Output mode
(SWG) by pressing the SETUP button.
2. To adjust the subwoofer line level output higher
press the button.
To adjust the subwoofer line level output higher
press the button.
SWG 00 = No gain.
SWG -12 = Minimum level.
SWG +12 = Maximum level.
3. Control reverts back to volume control after 5
seconds.
Note: If subwoofer output is turned off, Subwoofer
Line Level Output mode is not accessi
ble. See
Subwoofer Output (page 28) for more information.
CD