Installation manual

28
Sound Controls (Continued)
Subwoofer Output:
Press and hold the EQ button to turn subwoofer
output on and off. “SUBW ON” appears in the
display when the subwoofer is on and “SUBW
OFF” appears when the subwoofer output is off.
Loud:
To boost high and low tones at low volume lev-
els, press and hold the ENT BND button until
“LOUD ON” appears in the display. To deselect,
press and hold the ENT BND button again until
“LOUD OFF” appears in the display.
Mute:
Press and release the MUTE button to mute the
volume level. If a CD is playing the MUTE button
will pause the disc. Press the MUTE button again
to restore the volume or resume playing the disc.
Equalizer (EQ):
Press the EQ button to choose between the pre-
set equalizer settings: Rock, Pop, Classic, Vocal,
Flat and Jazz as indicated in the display area.
Subwoofer Cutoff Frequency (SWF):
1. Select the Subwoofer Cutoff Frequency mode
(SWF) by pressing the SETUP button.
2. To adjust the subwoofer cutoff frequency press
the or button.
SWF 160 = Low Pass 160Hz
SWF 120 = Low Pass 120Hz
SWF 80 = Low Pass 80Hz
3. Control reverts back to volume control after 5
seconds.
Note: If subwoofer output is turned off, Subwoofer
Cutoff Frequency mode is not accessi
ble. See
Subwoofer Output (below) for more information.
CD