Installation manual

8
Treble:
1. Select the Treble mode (TRB) by pressing the
SETUP button.
2. Increase the Treble by pressing the button.
Decrease the Treble by pressing the button.
3. Control reverts back to volume control after 5
seconds.
Balance:
1. Select the Balance mode (BAL) by pressing the
SETUP button.
2. To adjust the amount of sound output to the
Right speakers press the button.
To adjust the amount of sound output to the
Left speakers press the button.
BAL L=R = Equal sound right and left speakers.
BAL 10R = Right speakers only.
BAL 10L = Left speakers only.
3. Control reverts back to volume control after 5
seconds.
Sound Controls (Continued)
Fader:
1. Select the Fader mode (FAD) by pressing the
SETUP button.
2. To adjust the amount of sound output to the
Rear speakers press the button.
To adjust the amount of sound output to the
Front speakers press the button.
FAD F=R = Equal sound front and rear speakers.
FAD R10 = Rear speakers only.
FAD F10 = Front speaker only.
3. Control reverts back to volume control after 5
seconds.
Subwoofer Line Level Output (SWG):
1. Select the Subwoofer Line Level Output mode
(SWG) by pressing the SETUP button.
2. To adjust the Subwoofer Line Level Output
higher press the button.
To adjust the Subwoofer Line Level Output
lower press the button.
SWG 00 = No gain.
SWG -12 = Minimum level.
SWG 12 = Maximum level.
3. After 5 seconds control reverts back to volume
control.
Note: If subwoofer output is turned Off, Subwoofer
Line Level Output mode is not accessi
ble. See
Subwoofer Output (page 9) for more information.
DVD