Data Sheet

V1.03

Multifunctional POWER SHIELD 6+6 T800 for Arduino

Quick Start Guide

POWER SHIELD 6+6 T800 is an accessory for Arduino-type

boards. One POWER SHIELD can control 6 loads of different

types and voltages. Each power output can also be used as a

simple DC mode or a dynamic output, i.e. with the PWM (Pulse

Width Modulation) mode. By stacking two boards, you can

get more power and more channels. Four integrated LED indicators show performance

quality and error statuses. Feedback connections lead to the Arduino analogue inputs (one

for measuring current).

Main features

Power supply voltage 6.5…32V; output controllable voltage 1…32V

Single board max output power 800W; two stacked boards max 1.5kW

Multiple protections: overcurrent, overheat, FlashBack, polarity and other

Integrated 5V DC/DC converter to supply Arduino itself

1. Connect POWER SHIELD to an Arduino board:

2. Connect motors, LEDs or *anything else you need:

Note: If you are connecting motors, solenoids or something else with inductivity, use FlyBack diode for this load!

3. Download (simple or advanced) code or write your own sketch for Arduino.

4. Upload your sketch.

5. Turn on the serial monitor with a baud rate of 19200.

6. Switch the power on (by putting the fuse in its case).

7. Turn on SW2 and try to change SW1 positions while the device is working and see what happens

on serial monitor window.

* Before implementing your project, read the full user manual. This

document is only a Quick Start Do not follow this document for

long-term projects. Guide for board testing purposes.

www.v-vTech.com