Removal of Stock System: 1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators. Figure 1 2. Remove nuts from the exhaust flanges behind the catalytic converters. Refer to Figure 1 and 2. 3. Remove existing exhaust hanger by removing the two bolts on the hanger. Keep for reinstallation. Refer to Figure 3. Figure 2 4. Lubricate then remove hardware from the rearmost exhaust hanger. Keep for reinstallation. Refer to Figure 4. 5.
Installation of MBRP Inc. Performance Exhaust: 1. Install the Driver Side Extension Pipe using one of the provided Gaskets and existing hardware. Leave hardware loose enough for some adjustment. Refer to Figure 5. Figure 5 2. Slide a 2 ½” Clamp over the Extension Pipe and install it to the Driver Side Front Pipe. Refer to Figure 6. 3. Slide the existing factory hanger onto the Extension Pipe and reattach to the vehicle. Refer to Figure 6. Figure 6 4.
6. Slide a 3” Clamp over the outlet side of the Muffler. Position the Over Axle Pipe over the axle and loosely attach it to the Muffler. Install the Over Axle Pipe hanger into the factory rubber insulator. Refer to Figure 9. Figure 9 7. Slide a 3” Clamp over the Tail Pipe and install onto the Over Axle Pipe. Refer to Figure 10. 8. Slide the Tail Pipe hanger into the rearmost rubber insulator and reattach to the frame. Refer to Figure 10. 9. Install and adjust the Exhaust Tip to suit.