Installation of MBRP Inc. “Smokers TM ”: 1. Measure 20” across from the inside surface of the passenger side bed rail. Mark this location along the rail. This will be the approximate centerline of the Stack once installed. Refer to Figure 1. Figure 1 Figure 2 2. Using the Stack and the Band Clamp from the separately purchased Stack Kit, slide the Band Clamp over the Stack.
5. Confirm that the base of the Stack is resting in the same position as in Step 4. Re-trace and center punch if needed. This is where the Extension Pipe will pass through the floor. Remove the Stack from the bed of the truck. Drill a hole using a 6” saw. It may be required to cut a part of a bed floor rail away. Refer to Figure 4. Figure 4 6. Measure from the Extension Pipe slip joint to the exhaust system that you are connecting to.
10. Check along the whole length of the exhaust system to ensure that there is adequate clearance around fuel lines, brake lines and any wiring. If any interference is detected relocate or adjust. Shown with 6” X 36” Stack (B1660) Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your TM . We are certain you will enjoy your purchase. MBRP Inc.
