LEDPAR64 USER MANUAL 1
Table of Content Part I General Information 1.1 Introduction……………………………………………………………………………...3 1.2 Safety Information………………………………………………………………..……3 1.3 Unpacking…………………………………………………………………….………….4 1.4 Specifications……………………………………………………………….………....4 1.5 Features………………………………………………………………..………………4 Part II Installation and Operation 2.1 AC Power……………………………………………………………………………….5 2.2 Understanding DMX…………………………………………………………………....5 A. About DMX………………………………………………………………………...5 B.
PART I GENERAL INFORMATION 1.1 Introduction Thank you very much for purchasing the LEDPAR64, our 5-channel LED Par Lamp series product that can work in AUTO, AUDIO and DMX mode. To assure reliable performance it designed to, please read the instructions in this manual thoroughly and carefully before application. 1.
3. Unpacking The LED PAR PRO DMX has been thoroughly tested and shipped in perfect operating condition. Check the shipping carton carefully for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for damage and be sure all accessories necessary to operate the fixture have arrived intact. In case damage has been found or parts are missing, please contact the sales person for further instructions.
PART II Installation and Operation 2.1 AC power The fixture’s mains lead may require a grounding-type cord cap that fits your power distribution cable or outlet. Consult a qualified electrician if you have any doubts about proper installation. WARNNING: For protection from dangerous electric shock, the fixture must be grounded (earthed). The AC mains power supply shall have overload and ground-fault protection.
must chain multiple fixtures together through serial linking, never split your DMX connections unless you are using our splitter/signal amplifier such as SRL-144. D. DMX addressing All fixtures should be given a DMX starting address when using a DMX controller, so the correct fixture responds to the correct control signal. This digital starting address is the channel number from which the fixture starts to "listen" to the digital control information sent out from the DMX controller.
2.
0 1 1 1 MEDIUM 2 LOWEST A. Auto mode When dipswitches #9
are both set at OFF, the fixture works in Auto mode. Please check above DIPSWITCH SETUP for reference. B. Sound Active mode When dipswitch #9 is ON and dipswitch #10 is OFF the fixture works in Sound active mode. Please check above DIPSWITCH SETUP for reference. C. MASTER/SLAVE Mode Master: set the dipswitch #10 of one LED PAR Light to OFF; the other dip switches 1-9 control the speed of the programs.
PART III MAINTENACE AND CLEANING Please refer to the following points during the normal inspection: A. Be sure all screws and fasteners are securely tightened at all times. Lose screws may cause unexpected damage or injury. B. Electric power supply cables must not show any damage or frayed spot.
