User Manual

Notes about Master-Slave synchronization:
1. When the master machine is running, the light will send DMX-512
signals, however, it can’t be connected to the controller. If it is, they will
interrupt each other, and therefore cannot be synchronized.
2. While many lights are using master-slave synchronization, only one of
them can be master, or they can’t be synchronized.
The connection of Master-Slave synchronization as below:
Safety Notice:
 Please be sure to turn off the device before installation and
maintenance
 Please be sure when operating the device you have good
ventilation.
 This device is design for indoor use. Please keep it dry
whenever using. An authorized dealer or service agent
should do installation and maintenance.
 Do not use other voltage that not complied with the
instruction showed.
 Do not stare at the lighting source, it may damage you eyes.
 Do not operate unless there is stable voltage.
 Do not use it in a moist environment.
Please note: information is subject to change without prior notice.
LEDROBOSPOT
User Manual
Please read this user manual before using this product.