User Manual

MBTLighting.com SM100DMX “Flurry DMX” User Manual
3/3
4. MASTER/SLAVE mode with Z-6 controller box
A. Connect all fixtures with DMX signal cord and set the first machine in MASTER mode.
B. Connect the first machine with Z-6 controller box and the others are slaves.
C. Set DMX address of SLAVES 001 and the machine now can be controlled by MASTER/SLAVE
mode.
D. The Blue LED on MASTER will be off and Blue LED on slave will be on.
MAINTENANCE
Frequent maintenance will extend the Snow Machine.
1. Do not allow the snow liquid to become contaminated. Always replace the caps on the snow
liquid container and the snow machine liquid tank immediately after filling. Clear snow cloth and
filtrated tip.
2. Before storing, flush out the system with clean water.
TROUBLESHOOTING
If you experience low output, mechanical noise or no output at all, unplug immediately. Check
fluid level, the external fuse, remote connection, and power from the wall. If all of the above
appears to be OK, plug the unit in again. If snow does not come out after holding the remote
button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going
through the hose. If you are unable to determine the cause of the problem, do not simply
continue pushing the remote button, as this may damage the unit. Return the machine to your
MBT Lighting dealer.
TECHNICAL SPECIFICATION
Type： SM100DMX
Name: Flurry DMX Snow Machine
Voltage: AC/ 230V/50Hz AC/120V/60Hz
Power：1000W
Fuse: 250V/6.3A or 110V/10A
Volume of Snow: 1000MM
3
/MIN
Capability: 5 Liters
Dimension: L515*W257*H220MM
Weight: 12.5KG
Save these instructions
For more info, please visit mbtlighting.com or call us at 1-800-845-1922 or email at
[e-mail].