Network Hardware User Manual

- 3 -
IDLE RUN
THROTTLE
19492
1. Check engine oil level.
2. Check fuel level.
3. Set engine speed control in the middle position.
4. Move decompression lever (if equipped) to the up
position. (Located on top of the engine)
5. Use key (if equipped) or starting handle to start
engine (Refer to engine instruction book for proper
“Manual Starting” procedure.)
6. After starting return engine speed control to the idle
position and allow engine to reach operation
temperature.
7. During operation run engine at full throttle, when
excessive kickback is noticed maximum compaction
has been reached.
8. To stop, return throttle to the idle position and allow
engine to idle for one minute then move control to
stop position.
DIESEL PLATE
OPERATING INSTRUCTIONS
15832
15856
CAUTION
Machine may fall and cause
injury or damage if lifted
improperly.
16026
Lift only by lift hook
Weight~ #781(355kg)
UNLEADED GASOLINE
13481
U.S. PATENT 7,165,469
19326 HYDRAULIC PLATE
Safety Decals: GPR99/135 (Decal Set #16031)
ENGINE
OIL DRAIN
15845
12573
WARNING
ROTATING PARTS
can crush and cut.
Keep hands away!
FORWARD
REVERSE
14665
HYDRAULIC OIL
15844
13483
CAUTION
Wear approved hearing protection,
foot protection, eye protection and
head protection.
STOP
Read the Operating Instructions
before operating this piece of
equipment.
Keep unauthorized and untrained
people away from this
equipment.
ROTATING & MOVING PARTS!
Make sure all guards and safety
devices are in place.
Failure to comply could result in serious
bodily injury.
SHUT OFF the motor before servic-
ing or cleaning.
DO NOT RUN in an enclosed area.
The engine produces carbon
monoxide, a POISONOUS GAS.
15856
#13483
#15866
#14665
#16026
#15847
#15845
#12573
#13481
GPR99 = #15856
#01554
#19492
#15844
GPR99 = #15856
#01554
GPR135 = #15855
GASOLINE MODELS
#19326
GPR135 = #15855