Operation Manual
20
7. Connection and Operating Elements
12. Power cable
13. REC (record RCA output)
Connect a recording unit (not included) to the REC socket with a standard RCA cable (not included).
14. AMP (master amplier RCA output)
Connect an amplier (not included) to the AMP socket with a standard RCA cable (not included).
15. LINE / PHONO (two phono and two line RCA inputs)
Connect the audio input to the line / phono with standard RCA cables (not included).
16. Grounding screw GND
Connect the earth terminal to all connected analogue audio devices.
Make sure when mounting on a desk with other equipment that there is sufcient ventilation. Do not place the device on
a soft surface such as, for example, a carpet or a bed etc.
In addition, air circulation must not be obstructed by objects such as magazines, tablecloths or curtains. This can
prevent dissipation of heat from the device and can lead to overheating (re hazard). To ensure adequate ventilation,
there must be 5 cm of free space around the plug-in power unit.
Do not drill any holes or screws into the product in order to attach the device somewhere as this may damage it and
impair its safety.
When setting up the device, make sure that it has a secure footing and is on a stable surface as people could be injured
if the mixer fell down.
When setting up the device, make sure that the connection cable is not being pinched or damaged by any sharp edges.
Always lay the cables so that no-one can trip over them or become entangled in them. Risk of injury!
When selecting a location to set up the mixer, make sure it will not be exposed to direct, intensive sunlight, vibration,
dust, heat, cold or humidity. No other appliances with strong electric or magnetic elds, for example transformers,
engines, cordless telephones, radios or PCs may be located in the direct vicinity of the mixer as these could affect it.
In view of the variety of varnishes and polishes used for furniture, the base of the device might leave visible marks on the furniture
it is placed on as a result of a chemical reaction. Therefore the device should not be placed on valuable furniture without sufcient
protection.
The mixer is suitable for installation in a desk and as a table device. There are 4 mounting holes in the upper covering board for fastening when
mounting on a desk.
1. Connect the necessary inputs, outputs, ground, microphone and headphones.
2. Switch the power switch (1) to the off position (O). Insert the power plug on the power cable into a mains outlet of 220 – 240 V/AC, 50 Hz.
3. Turn the volume control of the master volume fader and PFL volume control all the way down.
4. Switch the power switch (1) to the on position (I).
5. Select the desired music and play it from the connected input devices
6. Now you can try out the individual functions of the mixer.
8. Installing the device
9. Operation