Operation Manual

6. Connections and Control Elements

FX SEND (ME1002 and ME1202)

1) FX SENDS control

The FX control is used as master control for the SEND FX socket. The control is used to set

the level of the FX sum signal at the SEND FX socket.

2) SEND FX socket

The FX sum signal is applied to the SEND FX socket. The socket is intended for connection

of an effect device.

If the FX sum signal is to be returned through a mono or stereo channel, the

FX control for the channel must be at the left stop to avoid feedback.

3) FX TO CTRL switch

Press the FX TO CTRL switch to put the FX sum signal on the CONTROL ROOM output,

the headphones socket and the LED level display. Only the FX sum signal is audible at the

CONTROL ROOM output and the headphones output.

CD/TAPE IN and CD/TAPE OUT

1) CD/TAPE INPUT socket

The outputs of a recording device (e.g. CD recorder) are connected to the CD/TAPE

IN sockets. This input can also be used as an additional STEREO LINE input, e.g. for

connection of a CD player.

The TAPE TO MIX switch must be pressed to send the CD/TAPE IN

signal to the MAIN MIX bus.

If the SOURCE SELECTION (RECORD) output of an ampliﬁ er is con-

nected, the SOURCE SELECTION selection switch can be used to

listen to the devices connected to the ampliﬁ er (e.g. CD player, tun-

er, etc.).

2) CD/TAPE OUTPUT socket

The inputs of a recording device (e.g. CD recorder) are connected to the CD/TAPE OUT sockets. The CD/TAPE

OUT signal is identical to the MAIN OUT signal. Alternatively, a hiﬁ ampliﬁ er can be connected to these asymmetric

outputs.

- +15

FX SENDS

FXSEND

FIX TO CTRL

CD/TAPE

INPUT OUTPUT