Specifications

13
AIR FILTER
The filter behind the air intake apertures on the front of E SERIES amplifiers should be cleaned or
replaced periodically, e.g. 3-6 months. (Filters in amplifiers located in more 'dirty' atmospheres may
require more frequent maintenance). Access is via the blue front panel retained by 2.5mm Hex screws.
The filter should be 'dry' cleaned, using a vacuum cleaner preferably. Running the unit without a filter is
not recommended unless it is within a 'clean room'. Replacement filter material is available.
No other regular maintenance is required.
If you have any doubt about carrying out this procedure, refer to a service engineer or
contact your dealer.
IF YOUR AMPLIFIER DEVELOPS A FAULT, PLEASE REFER TO YOUR SUPPLIER FOR SERVICE
AND TECHNICAL SUPPORT. DO NOT ATTEMPT TO REPAIR THE FAULT YOURSELF AS THIS
WILL INVALIDATE THE WARRANTY.
TECHNICAL SPECIFICATION
Main Specifications - E series Amplifiers
Parameter (Units) E90 E45 E25 E15 E100 E475
Output Power (per channel) (Watts)
8 ohms
2500 1250 700 450 1400 775
4 ohms 4800 2500 1350 850 2800 900
2 ohms
8200 4200 2400 1550 3700 NA
Output Power (bridged) ( Watts)
8 ohms
9600 5000 2700 1700 5300 1800
4 ohms
16400 8400 4800 3100 7400 NA
THD+N:(%)(4 ohms)
@1kHz (@1dB below max output power) <
0.15 0.015 0.008 0.008 0.08 0.008
@20Hz to 20kHz (@3dB below max output power) <
0.5 0.05 0.03 0.03 0.15 0.03
Gain Options (dB)
32/36/39 26/32/36 26/32/33 26/31/32 26/32/36 26/31/32
Sensitivity Options
(for maximum power)
(dBu)
13/9/6 15.7/9.7/5.7 13/7/6 11/6/5 16/10/6 11/6/5
Sensitivity Options
(for maximum power)
(Volts)
3.5/2.2/1.5 4.7/2.4/1.5 3.5/1.7/1.5 2.7/1.5/1.4 4.9/2.5/1.5 2.7/1.5/1.4
Frequency Response -
20Hz to 20kHz
(dB)
±1.0 +0 / -0.3 +0 / -0.3 +0 / -0.3 ±0.5 +0 / -0.3
Power Consumption:
Nominal @ 240v (4 ohms)
(Amps)
5.6 4.5 3 2.1 7 2.7
Power Consumption:
Nominal @ 120v (4 ohms)
(Amps)
11.2 9 6 4.2 14 5.4
Dimensions: (mm)
Amplifier: H x W x D
88 x 482 x 428
Boxed (shipping UK): H x W x D
230 x 580 x 560
Boxed (shipping - all except UK): H x W x D
250 x 610 x 600
Weight: (Kgs)
Amplifier: 11.78 11.42 10.16 9.8 12 10.62
Boxed:(shipping)
13.78 13.42 11.92 11.66 14 12.62
Additional Specifications
Input Impedance - Active balanced (k ohms)
20 20 20 20 20 20
Input CMRR (dB)
>60 >60 >60 >60 >60 >60
Hum & Noise
(dB below max output)
-105 -106 -105 -105 -105 -105
Damping Factor:
@1kHz into 8 ohms
>400 >400 >400 >400 >400 >400
Signal Limiters -
(set to prevent excessive clipping)
Yes Yes Yes Yes Yes Yes
Protection: Short circuit / DC output / Temperature
Yes Yes Yes Yes Yes Yes
Mains in-rush control.
Yes Yes Yes Yes Yes Yes
Output Power (watts) into 8 ohms
Sine wave @ 1kHz
2400 1100 650 400 1150 725
Continuous music with Crest Factor of 2.8 (9dB)
2400 1200 675 425 1300 750
Continuous music with Crest Factor of 4.8 (14dB)
2500 1250 700 450 1400 775
Continuous music with Crest Factor of 7.8 (18dB) 2600 1350 725 475 1480 825
Output Power (watts) into 4 ohms
Sine wave @ 1kHz
4500 2050 1200 775 2250 750
Continuous music with Crest Factor of 2.8 (9dB) 4400 2400 1250 825 2600 825
Continuous music with Crest Factor of 4.8 (14dB)
4800 2500 1350 850 2800 900
Continuous music with Crest Factor of 7.8 (18dB)
5000 2700 1350 875 2900 900
Output Power (watts) into 2 ohms
Sine wave @ 1kHz
7200 3300 2200 1350 3200 NA
Continuous music with Crest Factor of 2.8 (9dB)
6800 4100 2300 1500 3600 NA
Continuous music with Crest Factor of 4.8 (14dB)
8200 4200 2400 1550 3700 NA
Continuous music with Crest Factor of 7.8 (18dB)
8900 4300 2600 1600 3700 NA