Service manual

HCD-FR10W

As shown in the following figure, adjust the portion

of each slider to the boss with the

slider-1 to 5 (L) and the slider-1 to 5 (R) pushed in the arrow directions respectively (see Fig. 1).

Paying attention to the up/down direction of the pinion (slider) (see Fig. 2), install each pinion (slider)

so that the portion

of each pinion (slider) meshes with the portion

of each slider (see Fig. 3).

Note: Push in the pinion (slider) until the claw of the boss comes out above the pinion (slider) to lock.

pinion (slider)

pinion (slider) portion

slider portion

boss

slider-5 (L)

slider-5 (R)

slider-4 (L)

slider-4 (R)

slider-3 (L)

slider-3 (R)

slider-2 (L)

slider-2 (R)

slider-1 (L)

slider-1 (R)

(Fig. 1)

(Fig. 2)

(Fig. 3)

boss

claw

pinion (slider) portion

4-8. PHASE ADJUSTMENT BETWEEN PINIONS (SLIDER) AND SLIDER-1 TO 5 (L/R)

http://www.xiaoyu163.com