Service manual

HCD-FR10W

Pin No. Pin Name I/O Description

53 MUTE DSD O Muting on/off control signal output to the DSD decoder “H”: muting on

54 SQCK O Subcode Q data reading clock signal output to the digital signal processor

55 VSS — Ground terminal (digital system)

56 TRAY IN I Disc tray in detection signal input terminal Not used

57 TRAY OUT I Disc tray out detection signal input terminal Not used

58 GFS DVD I Guard frame sync signal input from the DVD decoder

59 MUTE CD O Muting on/off control signal output to the digital signal processor “H”: muting on

60 MUTE 2D O Muting on/off control signal output to the motor/coil driver “H”: muting on

61 SLED I Sled motor servo drive PWM signal input terminal

62 FG I Spindle motor control signal input

63 SP ON O Muting on/off control signal output to the motor/coil driver “H”: muting on

64 JIT I Jitter signal input

65 TE I Tracking error signal input from the DVD/CD RF amplifier

66 PI I Pull in signal input from the DVD/CD RF amplifier

67 FE I Focus error signal input from the DVD/CD RF amplifier

68 AVSS — Ground terminal (for A/D converter)

69 AVREF I Reference voltage input terminal (for A/D converter)

70 AVDD — Power supply terminal (+3.3V) (for A/D converter)

71 GFS CD I Guard frame sync signal input from the digital signal processor

72 SCLK CD O SENSE serial data reading clock signal output to the digital signal processor

73 TSD-M O Thermal shut down signal output to the motor/coil driver

74 FOK CD I Focus OK signal input from the digital signal processor

75 LOCK CD I GFS is sampled by 460 Hz “H” input when GFS is “H”

76 LDSEL O Laser diode selection signal output

77 SACD/DVD O SACD/DVD selection signal output “L”: DVD, “H”: SACD

78 I2C SIO I/O Communication data bus with the DVD system processor and system controller

79 IIC-CLK I/O

Communication data reading clock signal input or transfer clock signal output

with the DVD system processor and system controller

80 RXD I Serial data input from the RS-232C (for check)

81 TXD O Serial data output to the RS-232C (for check)

82 SDCLK RF O Serial data transfer clock signal output to the DVD/CD RF amplifier

83 SDATA RF I/O Two-way data bus with the DVD/CD RF amplifier

84 XWR O Write strobe signal output to the DVD decoder

85 XRD O Read strobe signal output to the DVD decoder

86 (PWE) — Not used

87 VDD — Power supply terminal (+3.3V) (digital system)

88 VSS — Ground terminal (digital system)

89 to 96 A0 to A7 O Address signal output to the DVD decoder

97 A8 O Motor/coil driver power save control signal output terminal Not used

98 XDRST O Reset signal output to the digital signal processor “L”: reset

99 EEP WP O Write protect signal output to the EEPROM

100 EEP CLK I Clock signal output to the EEPROM

http://www.xiaoyu163.com