User Guide

Using the WinGuard Scanner
100 Dr Solomon’sAnti-Virus
4. Select the Load WinGuard on startup checkbox at the top of the
Components property page.
5. Click OK to close the control panel.
Enabling the WinGuard scanner and its modules
Once you have all WinGuard components installed, you can use any of four
methods to enable them, in various combinations.
 NOTE: Enabling a module means activating it and loading it into your
computer'smemoryforuse.TheWinGuardscannercan startandremain
active in memory even with none of its modules enabled.
Method 1: Use the WinGuard shortcut menu
Follow these steps:
1. Right-click theWinGuard icon inthe Windows system tray to display
its shortcut menu.
2. Point to Quick Enable.
3. Choose one of the module names shown without a check mark. Module
names that have a check mark beside them are active. Those without a
checkmarkareinactive.Ifyouusethismethodtoenableamodule,it
remains enabled until you restart your Dr Solomon’s Anti-Virus or your
computer. At that point, its state will depend on whether you have
enabled or disabled the module in the Dr Solomon’s Anti-Virus
Properties dialog box.
Dependingonwhich combination of modulesyou enable, theWinGuard icon
will display a different state. To learn what the different icon states mean, see
“Understanding the WinGuard system tray icon states” on page 103.
Method 2: Use the System Scan Status dialog box
Follow these steps:
1. Double-clickthe WinGuard icon intheWindowssystemtrayto open
the System Scan Status dialog box (Figure 4-1).