User Guide

Using the WinGuard Scanner
102 Dr Solomon’sAnti-Virus
Figure 4-2. WinGuard Properties dialog box
2. For each module that you want to enable, click the corresponding icon
along the left side of the dialog box, then click the Detection tab.
3. Select the Enable checkbox at the top of each page.
As you do so, the scanner enables that module. Depending on which
combination of modules you enable, the WinGuard icon displays a different
state.
If you enable all of its modules, the scanner will display in the Windows
system tray, unless you clear the Show icon in the taskbar checkbox in the
System Scan Detection property page.
Method 4: Use the Dr Solomon’s Anti-Virus Console
Follow these steps:
1. Double-click the Dr Solomon’s Anti-Virus Console icon in the
Windows system tray to bring the Console window to the foreground.
2. Select WinGuard in the task list, then choose Enable from the Task
menu.
the Console will enable the System Scan module and any other module
you had enabled previously. You cannot use this method to enable
individual modules other than the System Scan module.