User Guide

User’s Guide 171
Using the WinGuard Scanner
Method 3: Use the WinGuard Properties dialog box
Follow these steps:
1. Right-click theWinGuardicon intheWindowssystemtraytodisplay
the WinGuard shortcut menu.
2. Point to Properties, then choosea module name to open the WinGuard
Properties dialog box (Figure 4-45).
Figure 4-45. WinGuard Properties dialog box
3. For each module that you want to disable, click the corresponding icon
along the left side of the dialog box, then click the Detection tab.
4. Clear the Enable checkbox at the top of each module page.
As you do so, the scanner will disable that module and make all of the
configuration options in that page unavailable. Depending on which
modules you disable, the WinGuard icon will display a different state.
If you disable all of its modules, the scanner will display in the
Windows system tray, unless you clear the Show icon in the taskbar
checkbox in the System Scan Detection property page. In that case,
WinGuard will not display an icon in the system tray.
Using this method to disable the module makes the disabled state the
module’s “default”state. If you lateruse theshortcut menu toenablethe
module, it will stay enabled only until you restart your Dr Solomon’s
Anti-Virus or your computer.