User Guide

Installing Dr Solomon’sAnti-Virus
52 Dr Solomon’sAnti-Virus
• Finish your installation. Leave the Scan Memory for Viruses
before Configuring checkboxclear,thenclick Skip Config tofinish
your installation. Setup will ask if you want to start the WinGuard
scanner and the Dr Solomon’sAnti-Virus Consoleimmediately.To
do so, select the Start Dr Solomon’sAnti-Viruscheckbox, then
click Finish. Your Dr Solomon’s Anti-Virus is ready for use.
 NOTE:If youhada previous Dr Solomon’s Anti-Virus version
installed on your computer, you must restart your system in
order tostart the WinGuard scanner. Setupwill prompt youto
restart your system.
• Choose configuration options for your installation. You can choose
toscanyour system,createan emergency disk, orupdateyour virus
definition files before you start the WinGuard scanner and the Dr
Solomon’s Anti-Virus Console.
To do so, select the Scan Memory for Viruses before Configuring
checkbox to have Setup start the Dr Solomon’s Anti-Virus
application briefly to check your system memory. Next, click
Configure.
SetupwillstarttheDrSolomon’sAnti-Virusapplicationtoexamineyour
system memory for viruses before it continues. If it finds an infection, it
will alert you and give you a chance to respond to the virus. To learn
about your options, see Chapter 3, “Removing Infections From Your
System.” If it finds nothing, the application will flash briefly as it scans
yoursystem,thenSetupwill displaythe firstoftwo configurationpanels
(Figure 2-10).