User Guide

Installing Internet Guard Dog™
12 Internet Guard Dog
Installing Internet Guard Dog
After closing all open programs, you are ready to install Internet Guard Dog
on your PC. Installation should go smoothly, however, if you do have
difficulties, see “Troubleshooting installation problems” on page 12.
To install Internet Guard Dog
1. Close all open programs.
2. Insert the Internet Guard Dog CD in the CD-ROM drive.
3. Inthe Int ernet Guard Dog Setup screen,click Install Internet GuardDog.

NOTE: If the setup screen doesn’t start automatically when you
close your CD-ROMdrive, click Startonthe Windowstaskbar,click
Run,thentyped:\setup. IfDisnotthedrive letterofyourCD-ROM
drive, substitute the correct drive letter.
4. Afterinstallationiscompleted,InternetGuardDog’sInterviewfeatureis
launched. Follow through the screen instructions and provide
information as needed.
NOTE: Only the Administrator can access this Interview feature of
Internet Guard Dog. For more information, see “Using the Internet
Guard Dog Interview” on page 15.
Troubleshooting installation problems
A failed installation can cause software problems that are difficult to track
down. The major causes of installation failure are:
• Hard drive errors
• Temporary files that conflict with the installation
• Attempting to install while other software is running
Follow the procedure outlined belo w to minimize th e affect that these
common conditions may have on your installation.