Installation guide

10
Automatically configure network settings
Before continuing, ensure that your DHCP server has two leases
available. One lease will be used for the Web Management Console,
and the other will be used for your computer.
NOTE: It is strongly recommended that you reserve the IP address to
be used by the Web Management Console using the UTM Firewall
device MAC address. In bridged mode, this is the top MAC address of
the three displayed on the UTM Firewall device itself.
1 From the Network Setup page, click the Connections tab, then
select the DHCP assigned checkbox (Figure 3). Information in
the IP Address and Subnet Mask fields will be ignored.
Figure 3 Connections tab
2
Click Update.
3 From the Start menu, select Control Panel, then double-click
Network Connections.
4 Right-click the Local Area Connection icon (or appropriate
network connection for the newly installed PCI appliance), and
select Properties.
5 Select Internet Protocol (TCP/IP), then click Properties.
uf_SG640_qig_700-2239A00_en-us.fm Page 10 Monday, October 12, 2009 12:06 PM