Installation guide

9
Set your password
1 Launch your web browser, and navigate to 192.168.0.1.
2 On the management console, select Network Setup from the
Network Setup menu. A login window displays.
3 Enter the initial user name and password for the UTM Firewall
device:
•User name – root
• Password – default
NOTE: If you cannot connect to the management console at
192.168.0.1, or if the initial user name and password are not
accepted, reset the UTM Firewall device to its factory default
settings. Press the Reset button on the UTM Firewall device’s front
panel twice within two seconds, wait 20 to 30 seconds, and try
connecting again.
4 Enter and confirm a password for your UTM Firewall device. This
is the password for the user root, the main administrator account
on the UTM Firewall device. It is important that you choose an
administrative password that is hard to guess, and that you keep
the password secure.
The new password takes effect immediately.
Configure network settings
In the row labeled Bridge, click the Modify icon. This step configures
the IP address for the Web Management Console. For convenience,
this is generally an unallocated IP address on your LAN.
If your LAN has a DHCP server running, you can set up the UTM
Firewall device and your computer to obtain their network settings
automatically. Otherwise, you must manually specify network
settings for both the UTM Firewall device and your computer.
• To obtain network settings automatically, proceed to
Automatically configure network settings on page 10.
• To manually specify the network setting, proceed to Manually
configure network settings on page 12.
uf_SG640_qig_700-2239A00_en-us.fm Page 9 Monday, October 12, 2009 12:06 PM