User guide

52
McAfee
®
GroupShield
™
7.0 User Guide Integrating with ePolicy Orchestrator 3.6
Installation
5
Installing GroupShield on the client computer
1 From the ePolicy Orchestrator console, select the Site or the Exchange Server on which
you intend to install GroupShield, then click the
Tasks tab. The deployment task page
appears.
2 Double-click the Deployment task. The ePolicy Orchestrator Scheduler dialog box appears.
3 Deselect Inherit under the Tasks tab and select Enable (scheduled task runs at specified
time)
.
4 Click Settings under the Tasks tab. The Task Settings page appears.
5 Deselect
Inherit. From the listed products, select Install from the list item given
against
GroupShield for Exchange.
6 Deselect Run this task at every policy enforcement interval.
7 Click
OK.
8 Click the Schedule tab. Deselect Inherit.
9 From the Schedule Task list item, select Run Immediately and click Apply.
10 Click
OK to complete the deployment task scheduling.
11 Send an agent wakeup call.
Upgrading from GroupShield for Exchange version 6.0.x NAP
settings
Assumptions:
 ePolicy Orchestrator version 3.6 is installed on the server.
 NAP files for GroupShield for Exchange version 6.0.2 or version 6.0.3 is
checked-in.
 NAP file for GroupShield for Exchange version 7.0 is checked-in.
 You have not created any new policies in the GroupShield for Exchange version
7.0 NAP settings.
Note
For information on sending an agent wakeup call, refer to Sending an Agent Wakeup
call on page 50.