User manual

ASSEMBLING AND ADJUSTMENTS
6 – English
General
Handle
Assemb ly
T op handle
Place the handlebar’ s tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
Use enclosed straps to secure cables to the handle. Do
not overstretch cables when mounting.
Settings
Handle height
• Loosen the lower knobs.
• Adjust the height. Tighten the knobs properly.
Cutting height
Mo ve the lever to the back for higher cutting height and to
the front for lower cutting height.
Catc her
• Fit the catcher bag.
• Attach the hooks in the upper edge of the chassis.
• Fit the bagger bottom in the discharge hole.
Mulc her insert
• Raise the discharge guard to mount / dismount the
mulch plug.
Hook the spring in the frame.
Filling with oil
• The oil tank is empty at delivery. Fill the oil slowly. See
instructions under the heading Maintenance. The
engine oil should be changed the first time after 5
hours running time.
!
IMPOR TANT! Prevent unintentional
starting by removing the ignition cable
from the spark plug.
NO TICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.