Installation Guide

Transport
The original packaging should be used when transporting
the robotic lawnmower over long distances.
To safely move from or within the working area:
1. Press the STOP button to stop the robotic lawnmower.
If security is set to the medium or high level (see
Security level on page 26 ) the PIN code has to be
entered. The PIN code contains four digits and is
selected when you start the robotic lawnmower for the
first time. See First start-up and calibration on page
21 .
2. Set the main switch in position 0 .
3. Carry the robotic lawnmower by the handle at the rear
under the robotic lawnmower. Carry the robotic
lawnmower with the blade disc away from the body.
CAUTION! Do not lift the robotic lawnmower when
it is parked in the charging station. This may
damage the charging station and/or the robotic
lawnmower. Open the hatch and instead first pull
the robotic lawnmower out of the charging station
before lifting it.
Maintenance
WARNING! When the robotic lawnmower is
turned upside down the main switch must always
be in the 0 position.
The main switch should be set in the 0 position
during all work on the mower’s chassis, such as
cleaning or replacing the blades.
• Inspect the robotic lawnmower each week and replace
any damaged or worn parts.
• Check especially that the blades and blade disc are
not damaged. Check also that the blades can pivot
freely. Replace all blades and screws at the same time
if necessary so that the rotating parts are kept
balanced. See Replacing the blades on page 36 .
Always use original blades and screws when
replacing.
CAUTION! Never use a high-pressure washer or
even running water to clean the robotic
lawnmower. Never use solvents for cleaning.
In the event of a thunderstorm
To reduce the risk of damage to electrical components in
the robotic lawnmower and its charging station, we
recommend that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wires) if there is a risk of a thunderstorm.
1. Make sure the wires are marked with the supplied
markers to simplify reconnecting. The charging
station’s connections are marked R, L and Guide.
2. Disconnect all wires.
3. Reconnect all the wires if there is no longer a risk of
thunder. It is important that each wire is connected to
the right place.
Installation
Presentation
This chapter contains information that is important to be
aware of when planning the installation.
Before starting the installation make yourself familiar with
what is included in the carton.
McCULLOCH ROB R600 McCULLOCH ROB R1000
Robotic lawnmower √ √
8 175 - 001 - 17.03.2017