Installation Guide
A clock symbol is displayed on the start page when the
timer settings are set. The clock symbol is black when the
robotic lawnmower is not allowed to mow due to a timer
setting.
Installation - ROB R1000
INSTALLATION
Remote start 1
Remote start 2
Test settings
Drive past wire
The following operating settings are available via this
selection in the main menu.
•
Remote start 1:
To control the robotic lawnmower so
that it can easier reach remote parts of the garden.
•
Remote start 2:
To control the robotic lawnmower so
that it can easier reach remote parts of the garden.
•
Test settings:
To check the above settings.
•
Drive past wire:
To set the distance over the boundary
wire that the robotic lawnmower should travel before
turning back.
For examples of garden settings, see
Garden examples on
page 29
.
Remote start 1
One important function with the guide wire is the possibility
to steer the robotic lawnmower to remote garden areas
when required. This function is very useful in gardens
where, for instance, the front and back are joined by a
narrow passage.
Remote start 1 Proportion
Distance
Proportion
With this function activated, (any option other than
Never
is selected) the robotic lawnmower will at times follow the
guide wire from the charging station to the remote area
and begin mowing there.
How often the robotic lawnmower must follow the guide
wire from the charging station is selected as a proportion
of the total number of times it leaves the charging station.
At all other times, the robotic lawnmower leaves the
charging station in the standard manner and starts to mow.
Proportion Never
Rarely
Medium
Often
Always
• The following five options can be selected;
-
Never
(0%)
-
Rarely
(approx. 20%)
-
Medium
(approx. 50%)
-
Often
(approx. 80%)
-
Always
(100%)
Select the percentage that corresponds to the size of
the remote area relative to the total working area. If the
remote area is for instance less than half of the total
working area, then
Rarely
should be selected. If the
remote area is for instance half of the total working
area,
Medium
should be selected. Compare with the
examples in
Garden examples on page 29
The default setting is
Rarely
.
Distance
Enter the distance in metres along the guide wire from the
charging station to the remote area where the robotic
lawnmower begins mowing. Tips! Use the
Test OUT
function to determine how far it is to the remote area. The
distance, stated in metres, will be shown in the robotic
lawnmower’s display.
Remote start 2
If the working area contains two remote areas, the guide
wire should be installed so that it reaches both areas.
Remote start 1
and
Remote start 2
can then be combined
to steer the robotic lawnmower to each area.
The settings for
Proportion
and
Distance
are carried out in
the same way as for
Remote start 1
.
The default setting is
Never
.
Take into account that the total figure for
Proportion
cannot
exceed 100%. If one has for instance selected
Often
for
Remote start 1
, then one can only select
Never
or
Rarely
for
Remote start 2
.
Test settings
In the
Test settings
menu, it is possible to test how the
settings for
Remote start 1
and
Remote start 2
work in the
working area in question.
Test settings Test IN
Test OUT
175 - 001 - 17.03.2017 25