Installation Guide

Test OUT Remote start 1
Remote start 2
Test OUT
The Test OUT function is used to test the installation and
to calculate the distance from the charging station to a
remote area.
To test the settings in Remote start 1 :
Park the robotic lawnmower in the charging station and
select Test OUT - Remote start 1 . The robotic lawnmower
will then leave the charging station straight away along the
guide wire and begin mowing after the designated
distance.
How to measure the distance from the charging station to
a remote area:
Enter a distance which beyond any doubt exceeds the real
figure. The maximum distance that can be entered is 100
m. Park the robotic lawnmower in the charging station and
select Test OUT . The robotic lawnmower will immediately
leave the charging station. The distance, stated in metres,
will be shown in the mower display as the robotic
lawnmower operates. Stop the robotic lawnmower at the
required position and note the distance. Enter the
displayed number of metres in the Distance field for the
working area in question.
If Remote start 2 has been activated, i.e. if another option
other than Never has been selected for Proportion , these
settings must also be tested. Remote start 2 test is
performed in the same way as for Remote start 1 .
Test IN
The Test IN function allows you to test how well the robotic
lawnmower docks with the charging station.
Test IN can only be performed after Test OUT has been
performed.
Selecting this function causes the robotic lawnmower to
travel directly along the guide wire towards the charging
station and to dock with it. The test is approved only if the
robotic lawnmower is able to dock with the charging station
at the first attempt. If the robotic lawnmower is unable to
dock on the first attempt, it will automatically try again. The
installation is not approved if the robotic lawnmower needs
two or more attempts to dock with the charging station.
Drive past wire
The front of the robotic lawnmower always passes the
boundary wire by a specific distance before the mower
turns around. The default distance is 25 cm, but this can
be changed if required. The minimum value is 20 cm and
the maximum value is 30 cm. Note that the distance given
is only an approximate value and should be regarded as a
guide. In reality, the actual distance the robotic mower
passes the boundary wire can vary.
Specify the number of centimetres you want the robotic
lawnmower to pass the boundary wire and press OK .
Security
Through this selection, settings relating to security and the
connection between the mower and the charging station
can be made.
SECURITY
Change PIN code
Security level
New loop signal
Change PIN code
Enter the new PIN code and press OK . Enter the same
code again and confirm by pressing OK . When the PIN
code is changed, a message stating that the PIN code has
been changed appears in the display momentarily.
Make a note of the new PIN code on the designated line
on the MEMO page in the beginning of the manual.
Security level
There are 3 security levels to choose from.
Security level
Low
Medium
High
1. Low
2. Medium
3. High
Low and Medium security prohibits access to the robotic
lawnmower if the PIN code is unknown. High security also
includes a warning that beeps if the correct PIN code is not
entered after a designated time period.
Function Low Medium High
Time lock X X X
PIN request X X
Alarm X
Time lock
This function means that the robotic lawnmower cannot be
started after 30 days without first entering the correct PIN
code. When the 30 days has passed the robotic
lawnmower will continue to mow as normal, but the Enter
PIN code message appears when the cover is opened.
Enter your code again and press OK .
PIN request
26 175 - 001 - 17.03.2017