Installation Guide
Remote start Proportion
Proportion Never
Rarely
Medium
Often
Always
With this function activated, (any option other than
Never
is selected) the robotic lawnmower will follow the guide
wire from the charging station to the point where the guide
wire connects to the boundary wire. It begins to mow when
it reaches this point. How often it must follow the guide
wire from the charging station is selected as a proportion
of the total number of times it leaves the charging station.
At all other times, the robotic lawnmower leaves the
charging station in the standard manner and starts to mow.
The following five options can be selected:
1.
Never
(0%)
2.
Rarely
(approx. 20%)
3.
Medium
(approx. 50%)
4.
Often
(approx. 80%)
5.
Always
(100%)
Select the percentage that corresponds to the size of the
remote area relative to the total working area. If the remote
area is for instance less than half of the total working area,
then
Rarely
should be selected. If the remote area is for
instance half of the total working area,
Medium
should be
selected. Compare with the examples in
Garden examples
on page 29
The default setting is
Rarely
.
Calibrate guide, ROB R600 only
The
Calibrate guide
function allows you to test if the
robotic lawnmower can follow the guide wire out from the
charging station.
To test the guide wire:
1. Place the robotic lawnmower in the charging station.
2. Select
Calibrate guide
and press
OK
. The robotic
lawnmower will now leave the charging station, run a
calibration process in front of the charging station and
then follow the guide wire to the connection point with
the boundary wire and then start mowing.
3. Check that the robotic lawnmower can follow the guide
wire all the way to the connection point with the
boundary wire.
The test has failed if the robotic lawnmower cannot follow
the guide wire all the way to the connection point with the
boundary wire. It is likely that the installation has not been
carried out in accordance with the instructions in
Installation of the guide wire on page 18
. Common errors
are for instance that there is not enough open space to the
left of the guide wire as seen facing the charging station or
that the guide wire is not laid at an angle on a steep slope.
See
Laying and connecting the guide wire on page 19
Rectify the installation and run a new test with
Calibrate
guide
.
Reset user settings
This function allows you to reset the robotic lawnmower to
the default settings it had when it left the factory.
1. Select
Reset user settings
in the menu and press
OK
.
Enter the correct PIN code and press
OK
.
About
The About menu displays information about the robotic
lawnmower’s model, serial number and the different
softwares.
28 175 - 001 - 17.03.2017